Start-Up Report

Start-up reports assist the warranty process and may be required to support warranty claims. They are a requirement for any extended warranty and must be submitted to Pentair within 30 days of installation or the extended warranty will not be accepted.

Distributor	Order Number
Installing Contractor	Phone
Sales Contact	Phone
Customer
Location

1	System Information

Size of Wet Well

Manufacturer

Discharge from Bottom of Basin

Discharge Location

Inlet from Bottom of Basin

Inlet Location

Type of Check Valves

Type of Piping

Does System Have Suction Gauges? Yes No

Suction Pressure Reading

Does System Have Discharge Gauges ? Yes No

Discharge Pressure Reading

Liquid Being Pumped

Temperature (°F)

% of Solid

Is Sketch or Photograph of System Available? Yes No

Any Additional Comments on System

Upload Sketch or Photograph

Files must be less than 10MB.

2	Electrical Information

Control Panel Part Number

Panel Rated Amps

Manufacturer

Voltage

Phase

Heater Size

Location of Panel to Wet Well

Incoming Line Voltage

Actual?

Voltage to Pumps

Actual?

Type of Junction Box

Manufacturer of Junction Box

Are Floats Installed in Wet Well? Yes No

Any Additional Comments on Electrical

Are Floats Set to Engineer's Specs? Yes No

Are Floats Wired for Proper Sequencing? Yes No

Are Heat Sensors Hooked Up? Yes No

Is the Seal Leak Detection Hooked Up? Yes No

3	Pump Information

Type of Pump

Serial Number of Pump

Voltage of Pump

Phase

RPM

Amps

Impeller Size

C.O.S. TDH

GPM

Voltage Supplied from Panel

Actual?

Actual Amperage (All Phases):

Define the Rotation of the Pump:

Clockwise
Counterclockwise

Any Additional Comments on Pumps

Method Used to Check Rotation:

Viewed from the Top
Viewed from the Bottom

4	Acknowledge

Acknowledge that all information is accurate and proper procedures have been followed.

Customer

Date

Start-Up Technician

Date